Gauge Wheel Arm Repair Kit John Deere 1700 ME5 Arms Case IH

Gauge Wheel Arm Repair Kit John Deere 1700 ME5 Arms Case IHPR1151A: GWA Repair Kit JD 1700 ME5 Arms The gauge wheel arm pivot is the #1 wear point on planters. This is caused by the fact that the ground load on the gauge wheel is offset from the center of the row where the arm contacts the adjustable stop. This offset load is supported by two points of contact between the pivot pin and the bore of the hub. These points wear and the arm starts to lean allowing the tire to pull away from the opener disk. Moving

The Copperhead Concave System has hard surfacing on each of the 90° notched bars to last 2-3000 separating hours

AIR CYLINDER READY

painted and installed the arms

› Work in virtually all soil and tillage conditions

40" cross tube

7010    7230

DISCS & HARDWARE FOR PULL TYPE CASE IH 5310 TOOL BARS

Furrow Cruiser Complete Case IH Conversion Kit-Shallow Depth

SINGLE NUTRI-MATE ONLY

bushing and washers to mount closing wheels with standard 40mm bearings

Just as we use the notched bars to slow the rotor down

& HARDWARE - AIR CYLINDER READY