BIQU TMC2130 Stepper Motor Driver Module with Black Heat Sink 3D Printer Part pens

BIQU TMC2130 Stepper Motor Driver Module with Black Heat Sink 3D Printer Part pensIntroduction: The TMC2130 is a high performance two phase stepper motor driver chip with a standard SPI interface and a simple step dir interface. Continuous output current up to 1. 2A, can withstand 2A peak current in a short time, very low noise, high load drive does not lose step. Specifications1, the subdivision is up to 256; 2. Support SPI interface control; 3. It will not lose the step when driving with high load; 4. The logic interface level

Connection size: same Bulldog

Insulation resistance: 500M

Power supply:Dual-way power supply design to avoid mutual impact (12V power supply is strongly recommended)The hot bed section supports 11A current

5mmFlange: DoubleMaterial: AluminiumGT2 Belt:Pitch: GT2Width: Approx

Specifications:Color: BlackMaterial: AluminumFunction: Heat dissipationSuitable for TMC2100 stepper motor driverPackage Included:40 x Heatsinks

lower heat

Description: These cases protect your FOR Uno from things like rogue wires that might short it out while still allowing full access to the board

long life and high thermal efficiency

PEI (Polyetherimide) sheets provide a 3D printing build surface that requires no tape

print save

such as glasses

TMC2208 single-axis stepping motor driver chip