1/2X4X96FSB Bucket Pin

1/2X4X96FSB Bucket Pin1 2" x 4" x 96" Flat single bevel, weld on cutting edge. Good to weld under the front edge of your bucket to give it a wear surface or to replace the front lip of your bucket. If it becomes the new front lip of your bucket you can drill or blow holes in it to match a bolt on edge if you like.

Its OD is 140mm and length is 100mm

it will fit over a 1" thick bucket cheek plate

This is a p410 flex pin for use with x410 series teeth

This bolt on End Bit has an industry standard part number of 6Y5840 and has 3 bolt holes

This is a cat j300 series style weld on adapter with industry standard part number of 3G6304 also 9w1304

This bolt on End Bit has an industry standard part number of T207994 and has 6 bolt holes

This is a V19tvy Esco style Super V twin pointed bucket tooth

This is a MTG Kingmet style general purpose or universal bucket tooth part # mg15u

This item is a milling bit puller

This bolt on Cutting Edge has an industry standard part number of X400040 and has 8 bolt holes

Also known as New Holland 85811992

This bolt on side cutter (can be welded on) is for loader buckets and has an industry standard part number of 253-0067 and are for Caterpillar 980-988 models